Model Specifications. Manufacturer(s). Datron. Instrument Model: Description: Autocal Multifunction Calibrator. Instrument Type(s). Calibrator. Application. Find great deals for DATRON AUTOCAL Multifunction Calibrator as Is. Shop with confidence on eBay!. Datron | Sale | Rental | Lease – Calibrator. Datron Calibrator. Contact us for pricing and availability. Description; Options.
|Published (Last):||5 May 2016|
|PDF File Size:||8.21 Mb|
|ePub File Size:||11.59 Mb|
|Price:||Free* [*Free Regsitration Required]|
Mechanical damage — The series contain several large transformers and are very heavy. Contact taclory for detaifs.
Datron 4700 General Calibrators
Allow time for thermal equilibrium to be reached before taking readings. Set the DC Cmrent Sta. A perfectly calibrated DMM would have an exact 1: The external frequency is not present, machine will perform out of specification. IT and 1— terminals internally fused at 1. Physical connections and mounting — getting it installed.
When the insuaimenl is in Error mode the displayed output voltage is modified by the gain error, so the threshold indications may not coincide exactly with 75V and 60V on the OUTPUT display. The method is described later in this section.
Omit Operation g if calibrating at zero or Full Range value. Resolution and Accuracy The maximum resolution is digits with a unique facility for displaying the specified accuracy of output current. The requested range or function option is not fitted.
This calibration affects all Voltage and Current Ranges! Set to IV Range, Hz; and adjust for corrected i. Remote Sense is automatically deselected. Balance one thermal EMF against another in opposition, where possible, switch and relay contacts, tenninais etc. Recall from a Different Memory To switch to a different stored frequency: Ohm leads with a load of lOOkOhms produce an error of approx. Legends are appended on the display as appropriate, and a leading zero is presented to the left of the decimal point for fractional values.
Refer to Section 4 page 4- 1 2. Tliis can be used for recording, the results of verifying any of the three stored specifications.
Showing Results for Datron Instruments (FLUKE)
Band set by i. Wi thin this loop, device should be sequentially enabied- Status byte sent by enabled device; If SBN, loop should be repealed. Set to its lOmV AC range.
Notify me of new comments via email. Four points are important: Zero offset the line does not pass through the origin. Avoid making connections through Nickel, Tin, Brass and Aluminium. Scientific or Engineering notation can be programmed, with or wthout descriptive legends. Similarly, lead and load inductances combine to increase the load impedance with datrob but heavily reactive loads should be avoided.
Programming Instructions — how the facilities have been transferred into remote commands. These can only be set or selected manually. When, transferred into guard, it chops tiie Master Reference voltage. In these cases it is permissible to reduce the resolution by datrron maximum of 1 digit only.
These calibrations are not fully traceable. Fit the two rear rack-mounting ears to the rear of the cabinet, with tongues facing forward. Do not connect null detector to shunt until the voltage across tlie shunt and the source voltage are close in value.
Datron Instruments (FLUKE) equipment for sale at Used-Line
The selected address can be temporarily displayed on the front panel when in manual control, by touching Error and then Guard. Select AC At operations: Terminators Two terminating characters are available, as programmed by code.
It can be comi. Tolerance Limit Calculatioris Refer to Appendix 4 pagepara 1.
For these equations to be valid, the procedure must follow the above sequence. These terms and conditions contain rules about posting comments. As the Auiocal 470 perform specific DC tasks, they are available only as defined by Table 8.