ASTM C142 EBOOK

C/CM – 10 Standard Test Method for Clay Lumps and Friable Particles in Aggregates, aggregates, clay lumps, friable particles, Aggregate, Clay. 13 Oct CLAY LUMPS AND FRIABLE PARTICLES IN AGGREGATE (ASTM-C) Test samples shall be prepared in accordance with ASTM. This standard is issued under the fixed designation C ; the number immediately This test method is under the jurisdiction of ASTM Committee C09 on.

Author: Yozshushicage Shalkis
Country: Puerto Rico
Language: English (Spanish)
Genre: Marketing
Published (Last): 8 June 2017
Pages: 370
PDF File Size: 14.89 Mb
ePub File Size: 16.30 Mb
ISBN: 581-9-28761-861-4
Downloads: 81543
Price: Free* [*Free Regsitration Required]
Uploader: Tugrel

The detritus is separated from the remainder of the sample by wet sieving in the manner prescribed in the following table. A number in parentheses indicates the year of last reapproval. Coarse aggregate sizes and minimum quantities per sample are as follows: Why we use the sample after astm c142 sieving as Astm c142 C; do we need to determine a small particle inn aggregates? Do not use the fingernails to break up particles, or press particles against astm c142 hard surface or each other.

Notify me of new posts by email. Based on this standard deviation, the acceptable range of two test results on samples from the same aggregate sent to different laboratories is 1.

CLAY LUMPS AND FRIABLE PARTICLES IN AGGREGATE (ASTM-C) –

Your comments are invited astm c142 for revision of this standard or for additional standards and should be addressed to ASTM Headquarters. Equipment and Materials Weighing device accurate to 0.

Roll and squeeze the individual particles between the thumb and forefinger. Your comments will astm c142 careful consideration at a meeting of the responsible technical committee, which you may attend. astn

The weighed specimens are spread in a thin layer on the bottom of a container and covered with distilled water astm c142 about 24 hours. Your email astm c142 will not be published. Originally published as C – 38 T. Clay and friable particles may be present in the form of lumps in natural aggregates.

TOP Related Articles  PASTO PANGOLA PDF

Sorry, your blog cannot share posts by email.

Full text of “C Standard Test Method For Clay Lumps And Friable Particles In Aggregates”

Classify any particles that can be broken with the fingers into fines removable by wet sieving as clay lumps or friable astm c142. For coarse aggregates, P shall be based upon the weighted average of the clay lumps and friable particles in each sieve size fraction. Search the c412 of over billion web pages on the Internet. Balances shall conform to the accuracy of the applicable sections of Specification Astm c142 Roll and squeeze particles individually between the thumb and forefinger to attempt to break the particle into smaller sizes.

Particles that can be degraded in this manner are classified as clay lumps or friable particles. Significance and Use 3. Fine aggregates shall consist of particles retained on a astm c142. Try to break down the particles but only with the thumb and forefinger. Users of this astm c142 are expressly advised that determination of the validity of any such patent rights, and the risk of infringement of such rights, are entirely their astj responsibility.

Active Risk Management

No Comments Mar 19, Add a Comment Cancel reply Your email address will not be published. After all discernible clay lumps and friable particles astj been broken, separate the detritus from the remainder of the sample by wet sieving over the sieve astm c142 in the following table: The fine and coarse fractions are then astm c142 as above.

To provide the quantities designated in 5.

That coarse aggregate fraction shall be assumed to contain the same percent of clay lumps and friable particles as that found in the next larger or smaller coarse astm c142 fraction. Notify me of follow-up comments via e-mail address.

Last previous edition C – 78 If they are near the surface, these lumps can cause pitting astm c142 the influence of traffic. The values given in parentheses are provided for information purposes only.

TOP Related Articles  HIDRAULICA GENERAL GILBERTO SOTELO AVILA EBOOK DOWNLOAD

A superscript epsilon e indicates an astm c142 change since the last revision or reapproval. Agitate the sieve during the wet sieving operation to assure removal of all undersized particles.

astm c142 The American Society for Testing and Materials takes no position respecting the validity of any patent rights asserted in connection with any item mentioned in this c1422. It is the responsibility of the user of astm c142 standard to establish appro- priate safety and health practices and determine the applica- bility of regulatory limitations prior to use.

To know more about me just visit AboutMe. The test sample shall have a mass not less than indicated in the following table: Precision and Bias 8. Individual reprints single or multiple copies of this standard may be obtained by contacting ASTM at the above address or at phonefaxor service astm.

Astm c142 the aggregates to cool and weigh to nearest 0.

CLAY LUMPS AND FRIABLE PARTICLES IN AGGREGATE (ASTM-C-142)

PariwutK March 18, Reply. Are clays and small particle may removed awtm washing? Til 2 Standard Test Method for Clay Lumps and Friable Particles in Aggregates 1 This standard is issued under the fixed designation C ; the number astm c142 following the designation indicates the year of original adoption or, in the case of revision, the year of last revision.

This standard is subject to astm c142 at any time by astm c142 responsible technical committee and must be reviewed every five years and if not revised, either reapproved or withdrawn. Test for Clay Lumps and Friable Particles Purpose Clay and friable particles may be present in the form of lumps in natural aggregates.